You must log in or register to comment.
Needs barbs, probably, and something better than tape.
So Horizon Zero Dawn
Honestly, one of the best “outcomes” humanity could hope for at this point.
The tip is not sharp enough.
This, but it’s a Meshtastic board powered by photovoltaic fletching so I can fire them high into trees to create a rogue comms network
nrf52840 I presume. ESP32 needs a bit too much battery for a bow.
I should probably read into them before the world goes belly up. At the moment, I’m only somewhat knowledgeable about ESP and Arduino.
let me help you rethink your design. the arrowhead is going to take too hard an impact for pcb. you want to put all that in the shaft near the fletching so you don’t have to run as much wire.
The funny thing is that that board is actually designed to be arrowhead-shaped, not just a shard sawn off a larger PCB. I wonder what it came from (assuming it’s real)?
Duh, it’s obviously from a smart spear that stopped working because it was part of a bot net.
“This hunting trip is brought to you by our sponsor, PCBWay.”
It does look close to PCBs you’d see in random key fobs but I think solid chance it’s a prop (or AI). If you look close and of course we do only see one side but a lot of the things you’d expect to see are missing. What could this do, how does it interact or connect to things, whats up with those traces and why are they going there, who made this and why is nothing labeled? None of that is definitive, but it’s weird to have that many questions like those on a real PCB.
The wiring is consistent (no ghost/empty wires) so likely not AI.
I noticed the same thing. Maybe it’s AI. I don’t see any inputs or power source and there’s no indication that there’s anything big enough on the other side to be either.
The big chip has 2 number one pin markings
Could be a car key fob maybe? CR2032 and buttons could fit on the backside
Maybe, but it would be huge. Most key fobs I’ve seen don’t need mounting screws either. I’m not sure about the battery holder, but any buttons on the other side would likely run through the pcb. I don’t think contact solder would be strong enough for repeated use. There would also be traces somewhere that come from the other side to the controller.
I don’t see any merging traces or other aspects of it that don’t make sense when looking at the board holistically, so I don’t think it’s AI.Edit: another commenter pointed out two “pin 1” marks on the biggest chip, so never mind, it’s AI. Fuck.With two microchips with that many pins (maybe a 4+ layer PCB?), it looks too complicated to be a key fob. It also has what looks like a 5-pin header for programming.
Perhaps a board from some form of drone that fits in the nose cone?
Edit: Never mind, saw the comment about the #1 pin.
deleted by creator
My retirement plan is to sell one ooga for two boogas.
Buy for an ooga, sell for tew.
“Where do you see yourself in fiver years?”
“Retired early or in an unmarked grave. Those are the only two options.”
That would be good news though. Either electronics got cheap again (enough to be used as arrowheads) or we’ve taken the chips back from the evil megacorps that are hoarding them.
Someone’s first hunt, good luck with that spear
I want to see someone knap an arrowhead from the fancy fighter jet sapphire cockpit winshield
I’d put a taser on the end of a stick so I have electrical damage added to my spear.
Hunting giant robo animals?
This is terrible. Those board components have terrible aerodynamics. You should scrape those off to improve the flight profile for the arrow
